Questions & Answers

Show me tell me driving test questions

Q1. Open the bonnet, identify where you would check the engine oil level and tell me how you would check that the engine has sufficient oil.

A1. Identify dipstick / oil level indicator, describe check of oil level against the minimum/maximum markers.

Q2. Show me / explain how you would check that the power assisted steering is working before starting a journey.

A2. If the steering becomes heavy the system may not be working properly. Before starting a journey two simple checks can be made. Gentle pressure on the steering wheel, maintained while the engine is started, should result in a slight but noticeable movement as the system begins to operate.
Alternatively turning the steering wheel just after moving off will give an immediate indication that the power assistance is functioning.

Q3. Open the bonnet, identify where you would check the engine coolant level and tell me how you would check that the engine has the correct level.

A3. Identify high/low level markings on header tank where fitted or radiator filler cap, and describe how to top up to correct level.

Q4. Show me how you would check the parking brake (handbrake) for excessive wear, make sure you keep safe control of the vehicle

A4. Apply footbrake firmly. Demonstrate by applying parking brake (handbrake) so that when it is fully applied it secures itself, and is not at the end of the working travel.

Q5. Identify where the windscreen washer reservoir is and tell me how you would check the windscreen washer level.

A5. Identify reservoir and explain how to check level.

Q6. Show me how you would check that the horn is working (off road only).

A6. Check is carried out by using control (turn on ignition if necessary).

Q7. Open the bonnet, identify where the brake fluid reservoir is and tell me how you would check that you have a safe level of hydraulic brake fluid.

A7. Identify reservoir, check level against high/low markings.

Q8. Show me how you would check that the direction indicators are working.

A8. Applying the indicators or hazard warning switch and check functioning of all indicators.

(if you need to switch ignition on – Do not start engine)

Q9. Show me how you would check that the brake lights are working on this car. (I can assist you, if you need to switch the ignition on, please don’t start the engine)

A9. Operate brake pedal, make use of reflections in windows, garage doors, etc, or ask someone to help. (Do not start engine)

Q10

Q10. Tell me how you would check that the brakes are working before starting a journey.

A10

A10. Brakes should not feel spongy or slack. Brakes should be tested as you set off. Vehicle should not pull to one side.

Q11

Q11. Tell me how you would check that the head lights & tail lights are working. (No need to exit vehicle)

A11

A11. Operate switch (turn on ignition if necessary), then walk round vehicle.

(As this is a “Tell Me” question, there is no need to physically check the lights.)

Q12

Q12. Tell me where you would find the information for the recommended tyre pressures for this car and how tyre pressures should be checked.

A12

A12. Manufacturer’s guide, use a reliable pressure gauge, check and adjust pressures when tyres are cold, don’t forget spare tyre, remember to refit valve caps.

Q13

Q13. Tell me how you would check the tyres to ensure that they have sufficient tread depth and that their general condition is safe to use on the road.

A13

A13. No cuts and bulges, 1.6mm of tread depth across the central 3/4 of the breadth of the tyre and around the entire outer circumference.

Q14

Q14. Show me how you would clean the windscreen using the windscreen washer and wipers.

A14

A14. Operate control to wash and wipe windscreen (turn ignition on if necessary).

Q15

Q15. Show me how you would set the demister controls to clear all the windows effectively, this should include both front and rear screens.

A15

A15. Set all relevant controls including; fan, temperature, air direction / source and heated screen to clear windscreen and windows. Engine does not have to be started for this demonstration.

Q16

Q16. Show me how you would switch on the rear fog light(s) and explain when you would use it/them. (No need to exit vehicle)

A16

A16. Operate switch (turn on dipped headlights and ignition if necessary). Check warning light is on. Explain use – When the visability less than 100m.

Q17

Q17. Show me how you switch your headlight from dipped to main beam and explain how you would know the main beam is on whilst inside the car.

A17

A17. Operate switch (with ignition or engine on if necessary), check with main beam warning light.

Q18

Q18. Tell me how you make sure your head restraint is correctly adjusted so it provides the best protection in the event of a crash.

A18

A18. The head restraint should be adjusted so the rigid part of the head restraint is at least as high as the eye or top of the ears, and as close to the back of the head as is comfortable. N.B. Some restraints might not be adjustable.

Q19

Q19. Tell me how you would know if there was a problem with your antilock braking system.

A19

A19. Warning light should illuminate if there is a fault with the anti lock braking system.

Questions & Answers

Show me tell me driving test questions

Quick Links

Contact Info